Stone Treatments
GRAFFITI H
Description: ANTIGRAFFITI SOLVENT BASED PAINT / GRAFFITI REPELLENT TREATMENT
Recommended Use
SUITABLE FOR ALL HONED, FLAMED, TEXTURED OR ROUGH SURFACE GRANITE, MARBLE, NATURAL AND ARTIFICIAL ENGINEERED STONES (LIMESTONE, SANDSTONE), TERRA COTTA, AND CEMENT BASED SURFACES.
• Effective for interior and exterior use
• Effective protection against paint, graffiti and felt pen marks.
• Highly recommended for exterior facades and monuments and head stone surroundings.
• Effective water and dirt repellent properties.
Properties:
GRAFFITI– H penetrates deep inside the stone creating an invisible barrier against graffiti attacks and due unique formulation is water and dirt repellent.
Product will not change the natural aspect of the stone or create any type of film, allowing permeability vapour moisture to escape, and is UV- resistant.
Important Safety Note: When using any type of solvent based product suitable ventilation should be provided during and after application .Use appropriate rubber gloves where necessary and do not smoke, eat or drink while using product. Keep product well closed and out of the reach from children. Additional information available on the MSDS SHEET (Material Safety Data Sheet).
STORAGE: - Keep product in cool and dry surroundings.
Application:
All stone surfaces to be treated must be completely clean and dry. Where no previous treatment experience exists a small discreet area should be tested to verify the suitability of the product to the stone. Where necessary ensure all surrounding areas and surfaces sensitive to solvents are protected against any spillage.
Apply one coat of GRAFFITI – H evenly by spraying using a low pressure pump up garden spray type unit or with a clean brush uniformly. The most efficient method is by spraying.
On very absorbent surfaces apply a second coat allowing sufficient time approximately 6 – 12 hours for your first application to penetrate into the stone and dry. If in doubt test discreet area to ensure second application is necessary.
In case of over treatment or any air bubbles remove by wiping excess product using a clean cotton cloth or absorbent paper.
Temperature of surface to be treated should not be below 10ºC. Avoid direct sunlight especially for external works.
Drying time: - Fully effective within 24 -48 hours before resuming normal use.
